How to install RGB color changing LED Strip lights Are you looking to add a touch of vibrant color to your space? Installing RGB color changing LED strip lights is a simple and rewarding project that can transform the ambiance of any room. Whether you’re a beginner or have some experience with electrical installations, this guide will help you get started. What You’ll Need Before we dive into the installation process, let’s gather the necessary materials: Read more: https://blls-lighting.com/author/edgarmdowns/ RGB color changing LED strip lights at your desired length RGB LED remote control RGB LED solderless connectors LED strip light power supply Optional: DC coaxial solderless connector Please note that it’s always advisable to consult with an electrician before undertaking any electrical installations. This guide is meant to provide general instructions and should not replace the services of a licensed electrician. Choosing the Correct LED Power Supply To ensure proper functionality, it’s crucial to select an appropriate power supply for your RGB color changing LED strip lights. Our LED strips operate on 12 volts and consume 2.2 watts per foot. Let’s do a simple calculation to determine the power supply you need. For instance, if you want to install 13 feet of RGB color changing LED lights, the total wattage required would be 28.6 watts. Using the formula watts divided by volts equals amps, we can determine the amperage needed. In this case, it would be 28.6 watts ÷ 12 volts = 2.38 amps. Keep in mind that it’s recommended to use a power supply with a maximum load that is 20% larger than the calculated amperage. This ensures efficient performance and prevents overheating. Based on the example above, a 4-amp power supply would be suitable. For additional information, refer to our LED Power Supply section. Read more: https://vk.com/ledlightsblls Long Distance RGB Installations with Amplifiers If you plan on installing RGB color changing LED strip lights over long distances, you may need to utilize amplifiers. Amplifiers help maintain consistent lighting throughout the entire installation, ensuring vibrant and even color changes. Installing the LED RGB Color Changing Strip Lights to the Control Box To begin the installation process, connect the LED RGB solderless connector or some extra RGB wire to the RGB remote. Make sure to strip the plastic off of the wire to expose enough bare wire for a secure connection. Tighten the wire down using the screw terminals. Verify that the (+), R, G, and B markings on the strip match those on the RGB control box. Once the RGB lights are hooked up, it’s time to install the control box to the power unit. There are two terminals for the (+) and (-) DC inputs from your power unit. Remember to turn off the power before installing the driver. Double-check all connections and then turn on the power. Use the remote control to enjoy full control over your LED strip lights. Read more: https://www.bondhuplus.com/edgarmdowns Frequently Asked Questions If your lights do not light up: Wire color does not always matter! Ensure that you follow the positive side of the flex strip down through the solderless connector wire to the power supply. Red/black can indicate either the positive or negative based on the side of the LED flex strip you’ve connected the connector to. For RGB installations, make sure the connectors are oriented correctly, with the right colors connecting to the right terminals. The solderless connector might be installed upside down. Repeat the steps above and try again. Ensure that the tray on the solderless connectors is fully closed. Handle with care. Check your power supply to ensure it is properly connected, with the correct polarity (+) and (-). Installing RGB color changing LED strip lights is a rewarding and relatively simple undertaking. By following these guidelines and seeking professional advice when necessary, you can enhance your space with vibrant colors and create a captivating ambiance.