speedometer inner cable are another exercise that can be worked with minimal equipment. Like biceps, practically everything you need can be found in your home gym. Arnold presses, barbell military presses (with a controllable weight), and side lateral raises are some of the most effective shoulder exercises which can all be done at home.

If your motherboard has a built-in video adapter you want to use, skip this section. A video card is not mandatory when you motherboard has an adapter, but it will greatly increase your gaming experience with a additional card.

If you have an AGP video card: Install the video card into the AGP socket. This is always the top expansion slot near the back of the computer. AGP slots are often brown, but can also be strange colors such as fluorescent green. Check the motherboard for levers (or similar devices) that are part of the AGP slot to help hold the card in place. These must be retracted before insertion of the card. Check the motherboard's manual for information on how to use these devices (if your motherboard has one.) Push the card into the socket (AGP slots are often pretty tight, don't be afraid to push it until it's well inserted), then screw it in at the top of the metal bracket. If it has a power connector, connect it to a 4-pin molex connector. If it has a pass through, do not connect it to a hard drive.

SPEEDO OUTER CASING
SPEEDOMETER WIRES

If you have a PCI Express video card, install speedometer wires the same way as an AGP video card, however the slot where it goes looks a little different having an extra spot on the slot as opposed to the 2 slot parts on an AGP slot. PCI Express slots used for video cards are commonly 16x as opposed to AGP 8x.

When your card is properly installed the line formed by the top of the card will be exactly parallel to the motherboard, if one side seems to be higher than the other, chances are that it's not fully inserted, press a little harder on the high side or pull it out and try again.

Video cards can also be dual installed if they are SLI capable.

STEP 7: HARD DRIVES / OPTICAL DRIVES (CD OR DVD DRIVES) / FLOPPY

Next install the hard drive and optical drives.

How a drive is physically installed will depend on the case.

When using an flexible inner core , plug the two connectors that are closer together into the 2 drives, and the third to the controller or motherboard. The connector furthest from the board should be attached to the drive set as Master. Make sure the drive that you will install your OS on is the primary master. This is the master drive on the Primary IDE bus which is usually the IDE 40 pin port on the motherboard labeled "Primary" or "IDE 1"..

 

 


want to know more, click http://www.dycables.com/